How to get the sensor into the process
Sensors as the direct interface to the process must be exactly matched to the chemistry of the measured medium and to the prevailing pressure and temperature conditions. Sensors in conjunction with suitable fittings and analyzers by Knick, top performance can be achieved, even in hazardous locations.
Because of the variety of production conditions, the requirements for a fitting are as diverse as they are for a sensor – pressure and temperature, the choice of materials, and above all the type and symmetry of the installation and the desired functionality, are determined by the fitting. There is a basic distinction between static fittings and retractable fittings. The static fittings are available as flow-through fittings, generally for by-pass or inline applications directly within the process flow, and as immersion fittings for measurements in basins, tanks or channels.
Retractable fittings can be used in manual or pneumatic mode to remove and service a sensor under process conditions. This can be linked with an automatic cleaning and/or calibration function.
Immersion fittings
Immersion fittings from Knick are the robust, precise and durable interface to measuring processes in tanks, basins and channels.
- adaptable to every process due to modular design
- simultaneous measurement up to three sensors
- different body materials: plastic or steel
- various process connections: pipe clamps, process flanges, and catenary suspensions
- immersion depths down to 2m
- individual sensor adaptions
- cleaning systems
The combination of an immersion fitting with a sensor lock-gate (Ceramat® WA160; see below) is unique, as shown under the retractable fittings.
Flow-through fittings
This is most common type of fitting. Flow-through fittings from Knick are used for measuring in a bypass or in the main stream with different flow directions and generally with shut-offs on the customer side for occasional sensor maintenance. Their modular design makes them suitable for use in all conceivable processes.
- simultaneous measurement up to three sensors
- safe and easy calibration with calibration chamber
- different body material: polypropylene, PVDF, or stainless steel.
- various process connections: DN and ANSI flanges, imperial or DIN screw fittings.
- various directions of flow
- individual sensor adaptions
- cleaning system
Inline fittings
Inline fittings from Knick are suitable for aggressive chemical processes as well as for processes with hygienic requirements. Expansion or replacement of components is possible at any time.
- fast and easy installations
- direct connection to pipelines or tank walls via coupling
- operation with special, pressurizable sensors possible
Retractable fittings
The successful SensoGate retractable fittings, now also available as hygienic versions, are ideally suited for manual, semi-automatic or fully automatic measurement, cleaning and calibration. The Ceramat is an automatic retractable fitting with unique ceramic sealing to the process. It is especially suited for extreme applications with difficult process media (corrosive, hot, toxic or under pressure).
- maintenance, calibration, and replacement of sensors with interrupting the process
- easy servicing of fittings due to modular design
- ceramic sealing to the process for maximum safety
- interference-free operation in fibrous and sticky processes
- immersion depths down to 2m
- low-priced version with replaceable push rod
- highly effective sensor cleaning
- seal rinsing during probe movement
- process-wetted materials: stainless steel or plastics
Direct connection of a conductivity sensor without fitting
The direct installation of certain conductivity sensors is also possible with special flanges as example on tanks or in the bypass or main stream.
Latest Posts
相关帖子
2月 2024
Process Analytics